I have LP8.5.6 running on a Mac Mini, OSX 10.4.11. When running a
large report I have intermittent problems in that I receive a blank
page back - no error, just nothing returned at all.

It seems that if I restart Lasso I can run the report a few times,
perhaps up to five, then I get the error. After the error occurs its
ongoing errors after that (ie I never get a report).

If I run Lasso in console mode I see it gradually eat up about 1.8GB
of RAM in one process when it is working on the report. After it
delivers the report it does not let go of the RAM, so no other
process can use it. I get the same errors in console mode, I do get
this printed:

Lasso8Service(1602,0x1d2ee00) malloc: *** vm_allocate(size=6778880)
failed (error code=3)
Lasso8Service(1602,0x1d2ee00) malloc: *** error: can't allocate region
Lasso8Service(1602,0x1d2ee00) malloc: *** set a breakpoint in
szone_error to debug
Lasso8Service(1602,0x1d2ee00) malloc: *** vm_allocate(size=5423104)
failed (error code=3)
Lasso8Service(1602,0x1d2ee00) malloc: *** error: can't allocate region
Lasso8Service(1602,0x1d2ee00) malloc: *** set a breakpoint in
szone_error to debug

I never get any report in the errors table.

Is there any way to get Lasso to release the RAM after processing the
report - I'm suspecting that this is the reason it fails after a few
successful attempts (runs out of RAM)?


-- Clive

#############################################################

This message is sent to you because you are subscribed to
the mailing list Lasso Lasso@lists.lassosoft.com
Official list archives available at http://www.lassotalk.com
To unsubscribe, E-mail to: <Lasso-unsubscribe@lists.lassosoft.com>
Send administrative queries to <Lasso-request@lists.lassosoft.com>